Mark's Locksmith

I bought an Fully Automatic Fishing Bobber on eBay and tried to make one close to it and this is what I came up with.

As of today, April 7th, 2023, I have not tried this but I will soon. I am working on other 3d printed projects.

Items needed:
1 - Two Springs - Extension Springs 7/32 inch x 1-1/2 inch
2 - One or Two fishing bead about 3mm or so.
3 - a small or large paper clip.

The "Top Bobber" is for the top of the bobber. You will need a paper clip to hole this in place.
The "Spacer Bobber" is for the bottom of the bobber. You will need a paper clip to hole this in place.
The "Bottom Bobber" is above the springs and below the Spacer Bobber.

Hopefully you can figure out the rest. Any questions, please ask and I will try to help you.

The filament I used is PETG. Resolution: .20, Infill: 50.
Support: Yes
Print the Main Bobber at an angle with support.
Print the Pole Bobber with support.